I didn’t know Dee Snider smokesd. Is Twisted sister touring again?Back on topic;
I didn’t know Dee Snider smokesd. Is Twisted sister touring again?Back on topic;
Here you go...@ShatsBassoon when you are hanging a door do you use a jig? Router, chisel or both?
Where am I going?Here you go...
Had a request for a 4.5" hinge set back 1.5" on the jamb so I had to make a jig. Here's my process:
Determine the distance from the outer edge of the router base to your cutting edge, cut out the appropriate amount on your jig. Place a strip of material the same thickness as your finish stock as a stop to determine your back route, and this also becomes the marker for where to screw the jig down:
Route it out...
Square off the corners and you're done.
Determine the distance from the outer edge of the router base to your cutting edge, cut out the appropriate amount on your jig. Place a strip of material the same thickness as your finish stock as a stop to determine your back route, and this also becomes the marker for where to screw the jig down.@ShatsBassoon when you are hanging a door do you use a jig? Router, chisel or both?
Did not expect her to sounds like a female.I will say... When she's not flexing or in mid workout she's pretty foxy.
View: https://www.instagram.com/p/B0W-xYrFAIW/?igshid=24pbx0bi94ix
Only tool you've ever used is a pencil sharpener. Shut up.Determine the distance from the outer edge of the router base to your cutting edge, cut out the appropriate amount on your jig. Place a strip of material the same thickness as your finish stock as a stop to determine your back route, and this also becomes the marker for where to screw the jig down.
After you route it out, square out the corners and you're done.
Only tool you've ever used is a pencil sharpener. Shut up.
Look how tight you have to hold onto that so your wrist doesn't go limp. 1¼ lbs. Lol.
There you go @Hauler, someone you can teach to get jiggy with itDetermine the distance from the outer edge of the router base to your cutting edge, cut out the appropriate amount on your jig. Place a strip of material the same thickness as your finish stock as a stop to determine your back route, and this also becomes the marker for where to screw the jig down.
After you route it out, square out the corners and you're done.
There you go @Hauler, someone you can teach to get jiggy with it
You're an unlicensed plumberLook how tight you have to hold onto that so your wrist doesn't go limp. 1¼ lbs. Lol.
Oh goodness, yes. Who wouldn’t ? I mean. Look at him!You love Chris Jericho
He was one of my favorite wrestlers growing up....I respect your taste.Oh goodness, yes. Who wouldn’t ? I mean. Look at him!
In conclusion:
He is THE BEST CHRIS, EVER.
Oh goodness, yes. Who wouldn’t ? I mean. Look at him!
In conclusion:
He is THE BEST CHRIS, EVER.
I have three favorites.He was one of my favorite wrestlers growing up....I respect your taste.
I have three favorites.
He’s obviously number one, but number two is a tie.
Maybe I have a type...